Skip to content
Snippets Groups Projects
electronics.md 13.08 KiB

Electronics Production

Introduction

I have worked with a CNC milling machine for my graduation project, at that time my instructor told me about using the CNC machine to produce a PCB since that I was curious about it. In this day I have learned about the PCB milling machine.

Design and milling

Machine set up

The day started by the design of the programmer. I have not designed it instead, I have downloaded it as a png picture. This website fabmodules is where the picture is converted to .rml format.

After the picture has been converter to the required format, I have started to set up the machine which is the SRM-20 machine.

The following images show the process of setting up the machine and preparing the spindle.

FR1 paper is used to produce the PCB, for the programmer one side paper is used, but for more complicated designs double side paper could be used. There are other types of paper like the FR4, but it is not recommended. When I was preparing the paper, I have hold it in the wrong way. My fingerprint can be seen in the following image, this may cause a short circuit if any design is produced over it.

The following photo also shows a number of milling bits. For the traces 1/64" bit will be used whereas 1/32" bit for the cover both are two flutes with the spindle diameter of 3.175mm. The cutting part of the bit must not too tall so that it does not break during the operation especially the traces bit.

The following image shows a rigid box of foam, this box is placed inside the machine because the bit can not go down in the z-axis and reach the paper. The following pictures show the process of placing the paper on the foam with a double face tape. During this process, I have checked several time for any bubbles. These bubbles will cause the surface to be uneven and may cause the bit to break.

Next step was to place the milling bit, this process is very sensitive, so the first thing to do was placing a sheet of cartoon over the FR1 paper to protect the bit if it falls down during the installation process. I have used two fingers also as shown in the following image to make sure the bit does not fall. I have fixed bit so that at least 20% of the spindle is visible for the purpose of setting up the zero z-axis.

Downloading the software

After setting up the SRM-20, I have downloaded the software starting from this link, I have opened an account on roland support to be able to download the software.

Producing the design