week00.md

1.1 Install Arduino IDE 1.8

You can find it at https://www.arduino.cc/en/software/OldSoftwareReleases

1.2: Add board to the board manager but pasting in link below
http://drazzy.com/package_drazzy.com_index.json
1. 3: Add the ATtiny mega board pack to board manager
1.4) Add JTAG to library
Add  jtag2udpi library by downloading pack
Pulled the zipped folder out of downloaded file (remove master form name)
Include zipped folder into the library
1.5) Open JTAG code and upload Ardunio Uno
1.6) Connect Uno board UDPI leg (6) to connect to UDPI leg on Tiny412 (6)
Ready to upload my first sketch

Another 20min and I am up and running!!
Void setup() {
  // initialize digital pin LED_BUILTIN as an output.

  pinMode(2, OUTPUT);} // the loop function runs over and over again forever

void loop() {

  digitalWrite(2, HIGH);   // turn the LED on (HIGH is the voltage level)

  delay(500);                       // wait for a second

  digitalWrite(2, LOW);    // turn the LED off by making the voltage LOW

  delay(500);                       // wait for a second
}
*void setup()

{ pinMode(1,INPUT);

pinMode(2,OUTPUT);

}


void loop ()

{   int button = LOW;

   button = digitalRead(1);

  if (button == HIGH) { digitalWrite(2,HIGH); } else {digitalWrite(2,LOW); }}

void setup()
{ pinMode(2,OUTPUT); }


void loop ()
{ digitalWrite(2,HIGH);}


And then


void setup()
{ pinMode(2,OUTPUT); }


void loop ()
{ digitalWrite(2,Low);}

void setup()

{

  pinMode(2, INPUT);

  pinMode(3, OUTPUT);

}


void loop()

{

  int x;

  x = analogRead(2);

 analogWrite(3,map(x,0,1000,0,255));


}