electronics production
Dude dude dude, I enjoy reading your documentation in this story format but, you need to add stuff to your page, here is a list.
"By using drill it will remove all unwanted copper from " actually it is a mill bit, not a drill.
Please link your teammates to their pages.
"where you are using small drill," mill bit, not drill. Drill is for holes, mill bit is for milling. :)
" should consider our drill sizes" mill
"If drill has to be changed VPanel is handy" Mill bit
"s the drill won't go evenly and ther" mill mill mill....
"tach the drill inside of " ....
"Finally drill could be released and adjusted to slightly touch the surface." ...and hopefully re-tinghtened again?
"Continue step must not be used with Z axis! This will most likely destroy the drill!" please explain why that is?
" In the end Save List has to be clicked. There could be multiple boards cut at the same time." did you actually use this? How do you set the origo for different boards?
"Simplified procedure of fabrication/milling process of PCBs:" On this list, you can not use PNG image, you need to have .rlm file from mods.
"Print PDF using Adobe Acrobat or similar software" what does this mean on your milling list?
"What is ability to drill between traces - till 0.1 mm" the values on the test pcb are parts of inch, no mm. Take note on this explanation.
Please define on the mods part what milling bits you used for what process. Add outline cutting explanation as well.
You need to explain the programmin phase in more detail. And add screenshots. And your command lines copied to the text are not correct.
add the hex file you loaded to the programmer.
-Jari