Commit 58acbd24 authored by Teddy Warner's avatar Teddy Warner
Browse files

Moulding & Casting Updates

parent d78e70e0
Pipeline #225442 passed with stage
in 36 seconds
......@@ -8,6 +8,8 @@
### Milling
Once we had the vectors created we started to work on the toolpaths. the first step was to set up the material. We were using 3/4th inch wood and the length and width were made a little bigger than what we needed. Once we verified that everything could fit, We used the 2d outline tool and selected the edge of each vector. The bit was already setup on the machine so we selected the 1/2th inch flat end tool and Aspire generated the toolpaths. We then exported the toolspaths from Aspire using the SBP format after simulating.
![](../images/week10/milledpart.jpg)
### 20T
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment