diff --git a/docs/projects/03make.md b/docs/projects/03make.md index 7210a66a8aff5929e7b07a932e51b2aa8aeda699..be1ee7f7956fd16559b988b8f7f86cbde7ff3efd 100644 --- a/docs/projects/03make.md +++ b/docs/projects/03make.md @@ -158,7 +158,7 @@ I used press-on snaps to connect the modules together. You could also use sew-on ## Power The simplest module! -[power_schematic] + * Cut a piece of fabric that's (dimensions?) @@ -180,15 +180,18 @@ The jack socket on the Amplifier module is soldered on. For an earlier prototype * Strip the ends of the wire and sew on ## Volume + ## Wendy -[circuit diagram] + * test after first oscillator * resistive strip can be replaced with actual resistor ## Ada + + Minimal sewing for this module! * 15mm wide strips of fabric are woven into a fabric grid. @@ -198,15 +201,18 @@ Minimal sewing for this module! Eeontex is super hard to get a hold of now, so you can substitute other conductive fabrics ## Maryam + + + This module was created using parametric design (Grasshopper for Rhino), and sewn using an embroidery machine. I've documented the process of designing the pattern, and the maths behind it [here](https://class.textile-academy.org/2019/jessica.stanley/projects/project_diary/week05/#exploring-space-filling-curve-designs-for-resistors), and instructions for machine embroidery [here](https://class.textile-academy.org/2019/jessica.stanley/projects/project_diary/week07/#embroidery-experiments) * The conductive thread used here is a linen/steel mix that looks white, but you could use any conductive thread. * The conductive thread is used as the bottom thread in the embroidery machine, because using it as the top thread results in serious tangles. This means you need to put the fabric in the embroidery hoop bottom-side up, as we still need the conductive thread to be on the top of the module. -* I did some experiments and adjusted the machine tension until I got clean, neat stitches. +* I did some experiments and adjusted the machine tension until I got clean, neat stitches that weren't too loose on either the top or bottom of the fabric. ## Daphne - + This module is a bit of a work in progress - it kind of works but it's not super reliable! @@ -215,12 +221,12 @@ This module is a bit of a work in progress - it kind of works but it's not super * Sew conductive traces ## Delia -[schematic] + ## Anni - + This module was made by hand, but you could also do some of the steps with a laser cutter! The resistivity of the yarn, as well as the spaces between where the yarns cross over in the 'loopy' part of the pattern, will affect the tones that the Anni module plays @@ -244,6 +250,7 @@ This module was made by hand, but you could also do some of the steps with a las ## Hedy + # Files and materials