Commit 8078da15 authored by Philip Hozier's avatar Philip Hozier
Browse files

wk8 update 2/5

parent 982b4fb0
Pipeline #228231 passed with stages
in 1 minute and 10 seconds
......@@ -359,5 +359,4 @@ Getting it to work is something i still need to work on!
| [Traces](../week10/3-axis-accelerometer-F_Cu_500.png "Traces") | The traces for milling. |
| [Interior](../week10/3-axis-accelerometer-Edge_Cuts_500.png "Interior") | The interior for milling. |
| [ATtiny412 datasheet](../week10/Attiny212-412_datasheet.pdf "ATtiny412 datasheet") | ATtiny412 datasheet. |
| [ADXL343 Accelerometer Datasheet](../week10/ADXL343-3Axis_Accelerometer-Datasheet.pdf "Accelerometer-Datasheet") | Accelerometer Datasheet. |
| [Traces](../week10/3-axis-accelerometer-F_Cu_500.png "Traces") | The traces for milling. |
\ No newline at end of file
| [ADXL343 Accelerometer Datasheet](../week10/ADXL343-3Axis_Accelerometer-Datasheet.pdf "Accelerometer-Datasheet") | Accelerometer Datasheet. |
\ No newline at end of file
......@@ -189,7 +189,7 @@ button as an input source to trigger the output response of the board.
| **Resistor (4.9k Ohm) x3** | To control amount of current going to the separate LEDs | | Non-polarity. |
| **Resistor (1k Ohm) x2** | To control amount of current going to the Red + Green of the RGB LED | Non-polarity. | Non-polarity. |
| **Resistor (499 Ohm)** | To control amount of current going to the Blue of the RGB LED | | Non-polarity. |
| **Button B3 SN** | Input source. | | Non-polarity. |
| **Button B3 SN** | Input source. | IC | Non-polarity. |
| **FTDI header pins** | To allow serial communication. | | Non-polarity. |
| **RGB LED, CLV1A-FKB** | RGB colour combinations. | [RGB-LED-datasheet.pdf](../week12/RGB-LED-datasheet.pdf "RGB-LED datasheet")| Polarity |
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment