John Story (b1c16d28) at 30 Jun 16:58
diary update
I will pass it but:
Add the link to the ATMEGA datasheet
I close the issue.
In the Simple Application section:
For the Application section:
Explain what your board is doing. Provide a link to the previous week if it was fabricated in a previous week.
Explain what your code is doing.
Explain a bit how did you modify the code coming from avrfreaks and the youtube vide.
Explain how did you program your board. Which software did you use? Explain a bit the toolchain? Which was the hardware setup? Which programmer did you use (it must be a programmer you have created previously
For the group work: Could you replicate the same exercise as simple code in other platforms (e.g. AVR, ARM and Raspberry Pi?). Check how we did last year.
Include the source code as downloadable code.
OK
Hello, You have good introduction and use of FreeCAD. Please, add also similar evaluation and selection of raster and 2D vector programs, like GIMP and Inkscape. And, add also results as files in original and common formats ( like JPG, PDF, STL...).
John Story (0e0b9f17) at 29 Jun 16:16
w3
John Story (f40d01ae) at 29 Jun 16:15
w3 typo
John Story (3e082dc6) at 29 Jun 15:34
w9 individual
OK. Unfortunately, we do not have time for @behnaz.norouzi to check it again, so I will approve it and close the issue.
Hi John,
You have done very interesting works for this week last year :)
From your documentation, I understood what you have done but the steps for how you did some things are missing. Therefore, please consider adding the followings to your documentation:
FOR VINYL CUTTING:
FOR PARAMETRIC DESIGN:
FOR LASER CUTTING:
FOR THE GROUP WORK:
It is good that you have the link to both 2021 and 2022 (Fab Lab Oulu) because although your 2021 group work looks really good, it does not include all the necessary tests; for example DPI and joint clearance and type. I also tag @ivanmilara here for this group work related matter to prevent any future issue with the global evaluator. To ensure your contribution to this year's group work (https://fabacademy.org/2022/labs/oulu/group_assignments/assignment_w04/), you can consider modifying the 2022 group work by adding some feedback, challenges or tips and tricks.
Bests,
Behnaz
John Story (070fe7ae) at 29 Jun 14:04
w3 vector mention
I can't find any raster images that are not already presented on the page. I think anything else is still on an old laptop. Other two things done.
John Story (bf67098e) at 29 Jun 12:38
w4
John Story (a28780eb) at 29 Jun 11:56
w4