Newer
Older
This week's class had a lot of new information, so it was quite difficult for me to follow everything.
To understand basics of communication protocols, this [basics of protocols series on circuitsbasics.com](https://www.circuitbasics.com/basics-of-the-spi-communication-protocol) was very useful. For effective communication between electronic devices, they need to use the same language. This language is called communication protocol. Some basic protocols are SPI, I2C and UART. These are generally slower than protocols like USB, ethernet, bluetooth and wifi, but are ideal for communication between microcontrollers and sensors where the large amounts of high-speed data does not need to be transferred.
Since I do not have access to a lab or a lot of inventory right now, I chose to understand wired communication protocols - SPI & I2C, with Arduino Unos that I do have access to. When I'm in the lab, or get more access to parts, I want to learn about the other wireless protocols too.
While communicating, bits are transferred from one device to another by quick changes in voltage. In a 5V system, O corresponds to 0V and 1 corresponds to 5V voltage.
In parallel communication, multiple bits are transferred at the same time through different wires. Whereas in series, the bits are transferred one after the other through the same wire. The following diagram shows the difference between the two.
### [SPI protocol](https://www.circuitbasics.com/basics-of-the-spi-communication-protocol)
### [UART protocol](https://www.circuitbasics.com/basics-uart-communication/)
### [I2C protocol](https://www.circuitbasics.com/basics-of-the-i2c-communication-protocol/)
I2C communication allows for a single or multiple masters(unlimited) to talk to a single or multiple slaves(max. 1008). It uses two wires to transmit data between devices. Since it follows series communication, it transfers bits one by one through the same wire.
* SDA (Serial Data) - to send as well as receive data between the master/s and slave/s
* SCL (Serial Clock) - sends the clock signal
The clock signal is controlled by the master, and the data is synchronized to the bit sampling.
Data is sent in messages. Here is a diagram of the structure of a message.
A pull-up resistor needs to be connected from the Master's SDA and SCL each to VCC, if there are more than one slaves or more than one masters.
I followed this tutorial and make a circuit to blink an LED on the slave.
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
### Task: Embedded Networking and Communications
1. Group assignment: Send a message between two projects
2. Individual assignment: design, build, and connect wired or wireless node(s) with network or bus addresses
### Student Checklist
1. Linked to group assignment page
2. Documented your projects
3. Documented what you have learnt fromimplementing networking and/or communication protocols
4. Explained the programming process/es you used
5. Outlined problems and how you fixed them
6. Included design files (or linked to)
