kerf

parent 108db976
Pipeline #92291 passed with stage
in 28 seconds
images/agreementEMAV.jpeg

87.6 KB | W: | H:

images/agreementEMAV.jpeg

129 KB | W: | H:

images/agreementEMAV.jpeg
images/agreementEMAV.jpeg
images/agreementEMAV.jpeg
images/agreementEMAV.jpeg
  • 2-up
  • Swipe
  • Onion skin
This source diff could not be displayed because it is too large. You can view the blob instead.
......@@ -101,8 +101,21 @@
</div>
Now, the laser cut is ready to work. It is time to use the software
</p>
<br><h4>Kerf</h4>
<p>
In order to make a more precise cut, we must take into account the kerf, since the measures cut may not be exactly the same as the measures designed.
To check these parameters, I will make a basic design and check the measurements.
<a title="Kerf design"><img class="image center" src="images/week4/kerf.jpg"></a>
<h6>Measure in milimmeters</h6>
Once the cut is made, we proceed to measure the design using a vernier, as seen in the picture.
<a title="Kerf measure"><img class="image center" src="images/week4/kerf1.jpg"></a>
<h6>Exterior</h6>
<a title="Kerf measure"><img class="image center" src="images/week4/kerf2.jpg"></a>
<h6>Interior</h6>
We can observe that we must have a consideration of 0.25mm of tolerance in the inner cuts for our designs.<br>
</p>
<h2>Create and Assembly</h2>
Once the parametric design has been obtained and the laser cutter has been prepared, it is time to use software to make the cut.
The software used is the Illustrator, this software can identify both vector and raster designs, although it works better in the vector format.<br>
......@@ -161,7 +174,7 @@
A first assembly with the first design with the final design is shown below, the change can be observed.
<a title="Two Assembly"><img class="image center" src="images/week4/twoassembly.jpg"></a>
As you can see the design on the right, the side blocks of the bridge are too big and makes the bridge deform with a new block.
The objective of the stability of the bridge is to have the blocks as long as possible with respect to the width, so we can have a wider structure.<br>
The objective of the stability of the bridge is to have the blocks as long as possible with respect to the width, so we can have a wider structure.<br>
The final and assembled press-fit kit is shown in the following image.
<a title="finalassembly"><img class="image center" src="images/week4/finalassembly.jpg"></a>
<br>
......@@ -300,6 +313,7 @@
<a href="images/week4/presfitkit.ipt" download>Press-fit kit.</a><br>
<a href="images/week4/protosl.svg" download>Protoss Logo Vector. (Inkscape)</a><br>
<a href="images/week4/protosv.dxf" download>Protoss Logo Vinyl.</a><br>
<a href="images/week4/kerf.dxf" download>Kerf design.</a><br>
</p>
<p><ul class="actions">
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment