week4 update

parent b88c9466
Pipeline #85822 passed with stage
in 27 seconds

20.7 KB | W: | H:


43 KB | W: | H:

  • 2-up
  • Swipe
  • Onion skin
......@@ -95,6 +95,7 @@
<li>We introduce the material to be cut, in this case we use 3mm corrugated cardboard.</li>
<a title="Cardboard"><img class="image center" src="images/week4/material.jpg"></a>
<li>Set the zero point as seen in the picture.</li>
A metal piece is used as a zero sensor and the work bed is moved with the panel selector, when the desired zero position is achieved, the selector is pressed. The complete procedure is observed in the following pictures:
<a title="Zero process"><img class="image center" src="images/week4/zero.jpg"></a>
......@@ -121,6 +122,7 @@
After this process, it is time to cut, but first we need to configure some parameters of the machine.<br>
<br><h4>Parameters configurations</h4>
The Illustrator software will be used for laser cutting and vinyl cutting, which will be seen later. This software works with vector images, which is the format that interprets the cutters, everything must be in vector.<br>
From the illustrator software we create a new document using the measurements of the work area of our laser cutter, as shown in the picture.
<a title="New"><img class="image center" src="images/week4/newIllustrator.jpg"></a>
We look for our file and we arrange it in the work area, it <b><strong><i>is very important to place the Stroke in 0.00025mm</i></strong></b>, after several tests in the laboratory, it is the indicated value for the cutter to know that it is a vector and make the cut.
......@@ -271,11 +273,19 @@
<li>After several tests in the laboratory, we use the following cutting parameters.<br>
Vel: 7<br>
Pres: 1<br>
Pass: 1</li>
Pass: 1<br>
Below is an image of the process of cutting the design.
<a title="Cutting"><img class="image center" src="images/week4/vinylcutting.jpg"></a>
<li>At the end of the cut, we must download the template with the cut<br>
<a title="Unload"><img class="image center" src="images/week4/unload.jpg"></a></li>
<li>The vinyl is removed as if it were a conventional sticker.<br>
<a title="Taking off"><img class="image center" src="images/week4/sticker.jpg"></a></li>
<li>Finally, this is the result of the vinyl cut.<br>
<a title="Result"><img class="image center" src="images/week4/result.jpg"></a></li>
Finally, this is the result of the vinyl cut.
<a title="Result"><img class="image center" src="images/week4/result.jpg"></a>
Markdown is supported
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment