Roland monoFab SRM-20 'Error 007'
Hi you all! I'm on IED Madrid fablab.
Sometimes, when using Roland monoFab SRM-20, the job stops and Vpanel reports this error pop-up.
'Resume' continues the job for a second but inmediately stops and the pop-up returns again and again, until pressing 'Cancel'.
I've read here and here something about 'g-code system' incompability between g-code generator (in this case fabmodules.org) and g-code runner (VPanel). We're pretty sure that fabmodules.org g-code generation and VPanel settings match.
Also it is mentioned something about drivers update and USB port changes.
No suggestion/solution worked in our fablab, but the drivers update by the administrator is pending.
I'm asking if anyone has/had this issue to find possible solutions and to share them by this way.
I'll advance any news.
Thanks.
Edu